I can't seem to find anything on this. Taking out the cable driving waste valves. May need to put in new waste valve with the handles in the down position. Is there any reason not to position them with the handle down instead of up or sideways?
My hydraulic slide sometimes stops on retraction. After a few minutes, it will start again and work. While I was checking voltages on the two hydraulic motor relays I found that the continuous duty relay is "on" as long as my key is on. Realy gets h...
I have Directv. H24 box. Dome Sat. on my motorhome and a dedicated satellite feed in the service bay. Dome and external sat feed go though an a/b/ switch. Tried two Winegard G2+ units, wired according to instructions. Neither would active the dish. ...
Do you know the make of the slide? Is it mechanical or hydraulic. If it is a Schwintek - they need a good battery even if plugged in to shore power. In any case check your battery charge. Also sometimes some slides work better if the rv is pointed do...
In our campground we have done several with Henry's tropic cool. With excellent results. Clean with Trisodium phosphate first. Can get at Home Depot. rv roof renew
Insead of replacing the nuts in the faucet hold downs with just plane hex nuts, use stainless steel wing nuts with washers. much easier replace, and removal if necessary no special tool will be needed.
If they are Kwikee steps, most likely the nylon gear is stripped. Need a new motor assembly. Easy install. Or if you are really mechanical you can take it apart and rotate nylon gear 180d. and it will work for a while longer. Just make sure to unplug...
