We are going camping in a few weeks in a state park in Colorado. We have been there many times and there are no full hook ups, only electric and we take a portable waste tank that we pull to the dump station. It is actually quite a drive, hilly and h...
I have a 20018 Montana Mountaineer. When I took a trip recently the slide outs halt for a few seconds and then continue, this will happen a few times until all slides are in/out. It never starts/stops at the same place and it happens on all three sli...
Just wanted to post a follow up message.I ended up buying a ryobi cordless pump, since I already had batteries. The only challenge I ran into is that both the pump and the valve cap had a male connection, which I could not connect the supplied water ...
Everyone, I appreciate all the feedback. I initially looked at a video of the macerator and they hooked up the water hose, but since then looked at the manual and it is indeed for cleanout only.Altough I like the idea of the macerator, I dont think I...
Just FYI, the battery was new.Replacing the breakers did resolve my problem and the slides operate smoothly again.Thanks everyone for helping me resolve this and especially for the picture of the breakers as I would never have recognized that!.
I pulled both breakers (they were inline) they seem to both be 12v 50A breakers. One of them is marked with (12V P43 50A) and the other one with (Shortstop 12V M48 50A).Do I need to worry about the "P43", "M48" and "Shortstop" designations?
I would never have recognized that as a breaker, I will take another look as I believe I know where it will be (think I might have 2) and try that before bringing it in for service.
