We are giving serious consideration to removing the carpet, or at least most of it, in our rv and installing something else. Perhaps Allure or something similar. My question is that upon looking at the carpet for removal the large slide has no roller...
I have a '08 Damon Daybreak, 3276 F53 chassis. The battery disconnect switch is located on the side of the step, which has stopped working. The switch checks OK, but I'm not sure where the solenoid is located, which I suspected was the problem anyway...
Well, this should all get "better" now with the soon to come driverless otr rigs in large close trains. Think how much safer that will be. Sorry, but I'm not personally liking the thought of any computer aided non human driven vehicle of any size, an...
I think you will find that it's not too bad of a job as long as you can get the bolts out of the spring eyes. If they are seized, I usually use a sawsall on the bolt (inside the shackle against the spacer/eye) and be careful not to cut the shackles. ...
I have the system installed on mine, front and rear both. I usually run from 60-70 psi in the fronts, but it depends on how I am loaded, number of passengers, towing, etc. I can say that you should try adjusting to lower or higher pressures until you...
There are a couple of butterfly type fasteners that you could use that would eliminate the necessity of pulling apart the undercarriage screening. I would assume that the fasteners would not be able to hit anything underneath such as wiring, etc and ...
If I was going to use a stop leak, it would be the one which consists of the aluminum flakes. I have used it a few times in the past and it worked every time, without clogging all of the core passages or leaking again after a period of time unlike Ba...
