Hi all,Has anyone removed the circuit board from the control box on an HWH leveling system? Mine is a 325a system and I can see, and have removed, 2 screws from the bottom edge of the board but it is still attached very tightly to the inside of the m...
Hi all,The MPPT controller on my coach will deliver 14.6 volts in bulk mode which is fine. In fact it’s exactly what the specs on my GC2 house batteries call for. But when I turn on the engine and the system connects the coach and starter batteries t...
...and then tell me how you did it.I have an appliance that is rated 130 watts at 110 volts (house current). How many amps per hour will this appliance draw from a 12 volt battery?TIAEric
Also, I found a large capacitor with a broken leg. I might have broken it. Took the board and the capacitor down to my local electronics supply place and he soldered a new one on for me. I described what the board is and he doubted that the capacitor...
So, for the archives, it helps to be smarter than the connectors you're trying to separate. The clips with hooks are not meant to be lifted. You are supposed to squeeze them in and then the connector will come out. They're hooked like that just to st...
I think you’re right. It’s probably glued on with years of grime. I’ll try and get some solvent, maybe brake clean, in there and keep wiggling it. Thanks.
This is a shot of the connector, CN2. The smaller brown part attached to the orange part with the wires sticking out of it is what I'm trying to pull out. The larger brown part is screwed onto the back of the silver metal box that holds the PC board....
Yup. Here's quote from that section"If the YELLOW and RED LED’s are lit check the correct pinsin the BROWN CN2 connector for +12 and ground. If +12 or ground is not present replace the control box."All the LEDs are lit but I do not have +12 at pin 5 ...
