....of my 2002 Arctic Fox 24.5N FW and I have some questions: When I took the old coroplast off, the bottom of the holding tanks were sagging downward a little, thus causing the coroplast to sag downward. I plan on putting 1" rigid insulation between...
JoeH wrote:dpglifestyle wrote:As far as the bulge from the tank you can run a steel strap from frame rail to frame rail under the tank. Install with an empty tank, pull tight and screw to the frame. A lot of units come this way. I would put a strip o...
So, after looking at this project for the last half hour, due to the sagging tank bottoms not allowing me to put any thickness of rigid insulation on them, I think I am going to furr out the bottom rails of the frame I beams with 1.5" pressure treate...
agesilaus wrote:Fabric based? What are you using? We assume foam board insulation which has no fabric in it so far as I know. It is glued with 'liquid nail' type cement they have some designed for foam boards. You'll find that at your big box hardwar...
valhalla360 wrote:I don't think you will be able to insulate the bottom of the slide as it has to go up over the interior floor when it's pulled in. Or maybe I'm not understanding what you are proposing.I am talking about insulating the part of the f...
