cancel
Showing results forย 
Search instead forย 
Did you mean:ย 

Slide-out question

C_J1
Explorer
Explorer
Our motorhome has been in storage, outdoors, for 4 years, with the slides in. Is there anything special we need to do before we extend the slides?
2011 Itasca Sunova 33C
10 REPLIES 10

wa8yxm
Explorer III
Explorer III
Once extended, at least a little bit, LUBRICATE, LUBRICATE Oil them suckers up.

Follow manufacturer's (Slide out) recommendations as to lubricant and how much.
Home was where I park it. but alas the.
2005 Damon Intruder 377 Alas declared a total loss
after a semi "nicked" it. Still have the radios
Kenwood TS-2000, ICOM ID-5100, ID-51A+2, ID-880 REF030C most times

Mr_Mark1
Explorer
Explorer
C&J, just curious, why was the motorhome not exercised in 4 yrs.?

Safe travels,
MM.
Mr.Mark
2021.5 Pleasure Way Plateau FL Class-B on the Sprinter Chassis
2018 Mini Cooper Hardtop Coupe, 2 dr., 6-speed manual
(SOLD) 2015 Prevost Liberty Coach, 45 ft, 500 hp Volvo
(SOLD) 2008 Monaco Dynasty, 42 ft, 425 hp Cummins

C_J1
Explorer
Explorer
We like Effy's advice. We know the slides might be the least of our problems!
2011 Itasca Sunova 33C

Effy
Explorer
Explorer
Pray.
2013 ACE 29.2

timmac
Explorer
Explorer
Besides the slide sticking issue has the motor or jenny been ran during these 4 years, how bout the gas, I would be most concerned on this than slides at this time.

C_J1
Explorer
Explorer
Moving the slides out just a hair initially sounds like a great idea.

Thanks again to all.
2011 Itasca Sunova 33C

DutchmenSport
Explorer
Explorer
In 4 years, rubber can stick to about anything very good! A modification to the suggestion above.... hit the retract button for just a second to just initially move each slide and then stop. This will move the slide out a tiny bit. It needs to be just enough you can get a finger between the rubber and the side of outside wall of the camper.

Now, that you can get your finger between the two, simply slide the finger all the way over the rubber, all sides. It' might be easier too, if you get some RV rubber slide-out conditioner to help soften it and let your finger slide a bit easier.

The idea is to make sure the rubber seal is not sticking to the side of the outside wall, so it won't rip to shreds the first time you try to retract. It may take a few minutes to do this, but it will take a lot longer to replace the rubber if it tears.

C_J1
Explorer
Explorer
Thanks for the responses. I especially like the idea of checking the seals before deploying the slides.

Four years in storage was not our choice, but now we're eager to get back on the road again!
2011 Itasca Sunova 33C

tropical36
Explorer
Explorer
C&J wrote:
Our motorhome has been in storage, outdoors, for 4 years, with the slides in. Is there anything special we need to do before we extend the slides?

That's a long time, but after being sure it's level and the batteries up, give it a go and see what happens. All else fails, so it manually and even though you, you've given no info on your rig, there's usually a way to do it.
"We are often so caught up in our destination that we forget to appreciate the journey."

07 Revolution LE 40E_Spartan MM_06 400HP C9 CAT_Allison 3000.

Dinghy_2010 Jeep Wrangler JKU ISLANDER.

1998 36ft. National Tropi-Cal Chevy Model 6350 (Sold)

rgatijnet1
Explorer III
Explorer III
Remove the slide lock. Make sure the batteries are all fully charged. Maybe run something along the edges to make sure that the seals have not stuck to the side of the coach so that they are not torn when the slide is extended.