cancel
Showing results forย 
Search instead forย 
Did you mean:ย 

King Jack ant.

ScottG
Nomad
Nomad
I want to install a Jack ant on our new TT. The location it would have to go is a bit tight because there's a cabinet door that would swing over the inside part.
Can anyone who has one of these tell me what the overall height of the inside control unit is?
I have 2.75" of clearance.

Thanks,
Scott
6 REPLIES 6

rjsurfer
Explorer
Explorer
Scott,

I'm thinking about swapping out my Jack passive OmniPro antenna and would like to know what size holes you had to make to install the King Jack version,

And any thoughtful tips on the job.

Thanks

Ron W
03 Dodge 2500 SRW,SB,EC
2018 Keystone 25RES
DRZ-400SM
DL-650

ScottG
Nomad
Nomad
Thank you both Merrykalia and chindog. I had actually emailed King and when they finally got back to me, they said it was 1". I had installed one in our last TT and pretty much knew that was wrong.
It's folks like you that make this forum great again (sorry). ๐Ÿ˜‰

Scott

Merrykalia
Explorer
Explorer
I measured ours and it was a bit more than the 1 7/8, but less than 2".
2017 Ford F350 Crew Cab 6.7L 4x4 DRW

chindog
Explorer
Explorer
The bottom of the tuning knob is 1.75" below the roof.
2014 Fleetwood Discovery 40G
2012 Honda CRV toad

ScottG
Nomad
Nomad
Merrykalia wrote:
We have one on our camper and it doesn't hang down far at all. Maybe 1.25". I will try to get out there and measure it this afternoon.


Thank you so much!

Scott

Merrykalia
Explorer
Explorer
We have one on our camper and it doesn't hang down far at all. Maybe 1.25". I will try to get out there and measure it this afternoon.
2017 Ford F350 Crew Cab 6.7L 4x4 DRW