Good Sam Club Open Roads Forum: One very last water tank question
Open Roads Forum Already a member? Login here.   If not, Register Today!  |  Help

Newest  |  Active  |  Popular  |  RVing FAQ Forum Rules  |  Forum Posting Help and Support  |  Contact  

Search:   Advanced Search

Search only in Folding Trailers

Open Roads Forum  >  Folding Trailers

 > One very last water tank question

Reply to Topic  |  Subscribe  |  Print Topic  |  Post New Topic  | 
Page of 2  
Prev
Npdchief07

Hamilton, Oh

Full Member

Joined: 01/28/2017

View Profile


Offline
Posted: 06/24/19 05:25am Link  |  Quote  |  Print  |  Notify Moderator

Thank you. Can you advise on what page you see info about the circuit breaker reset on side of tank?

opnspaces

San Diego Ca

Senior Member

Joined: 12/22/2004

View Profile


Offline
Posted: 06/25/19 10:13am Link  |  Quote  |  Print  |  Notify Moderator

The diagram is on the right side of page 6 showing it connected with red wires. The picture is on page 18, unfortunately there is no picture of the actual location on the water heater. You might have to peel back some insulating foam on the side of the tank or remove an access panel to see the switch. Page 22 has a troubleshooting section that might help also.


2001 Suburban 4x4. 6.0L, 4.10 3/4 ton
2005 Jayco Jay Flight 27BH
1986 Coleman Columbia Popup.

Npdchief07

Hamilton, Oh

Full Member

Joined: 01/28/2017

View Profile


Offline
Posted: 06/25/19 03:32pm Link  |  Quote  |  Print  |  Notify Moderator

Thank you

Old-Biscuit

Verde Valley

Senior Member

Joined: 06/20/2009

View Profile



Posted: 06/27/19 11:42pm Link  |  Quote  |  Print  |  Notify Moderator

Suburban SW6D.....

1) DC Voltage goes to on/off switch from a FUSED source (DC Dist Panel)
2) From switch it goes to a DC Junction box on left side of tank from the rear----wire nuts used to connect wires ---check if loose)
3) From the DC Junction Box the wiring goes to the set of t-stats --- High temp first then down connecting wire to Normal Temp
**(High temp trips if normal temp fails----manual reset via the PUSH TO RESET cover above gas valve---right side is for the propane Red Wires)
(Left side for 120VAC ---yours will only have the one on right side)
[image]

4) From the t-stats DC goes to circuit board ---backside of tank or attached to cabinet wall
5) DC then goes from circuit board to Gas Valve AND spark Electrode



Follow the DC to switch/from switch/from t-stat etc
[image]


Is it time for your medication or mine?


2007 DODGE 3500 QC SRW 5.9L CTD In-Bed 'quiet gen'
2007 HitchHiker II 32.5 UKTG 2000W Xantex Inverter
On the Road Debt Free April '07
Off the road still Debt Free Jan. '14

Reply to Topic  |  Subscribe  |  Print Topic  |  Post New Topic  | 
Page of 2  
Prev

Open Roads Forum  >  Folding Trailers

 > One very last water tank question
Search:   Advanced Search

Search only in Folding Trailers


New posts No new posts
Closed, new posts Closed, no new posts
Moved, new posts Moved, no new posts

Adjust text size:




© 2020 CWI, Inc. © 2020 Good Sam Enterprises, LLC. All Rights Reserved.