schlep1967
Harrisburg, PA
Senior Member
Joined: 12/08/2005
View Profile
Good Sam RV Club Member
|
Well sort of...
Our 2009 5th wheel has a Max Air cover over one roof/fan vent next to the shower. I realized last week that even though the cover has caulking around it, the back side is not sealed as it is in fact a screened vent. This made me think that I have never had the cover off to inspect the actual seal around the vent. So last night I got on the roof to check things out.
What I found was that having the front and sides of the max air cover sealed basically holds any water that may get in there inside where it will sit until it evaporates. OR it will find any entrance around the actual fan that has not had any caulking replaced in the ten years I've had the camper.
So this is a heads up to those with Max Air type of covers. Remove the cover every few years and check the caulking that actually seals the vent/fan to the roof.
2021 Chevy Silverado LTZ 3500 Diesel
2009 Open Range 385RLS
Pull-Rite Super Glide 4500
|
EMD360
Arvada, CO
Senior Member
Joined: 01/18/2010
View Profile
Good Sam RV Club Member
|
I use eternabond tape. It lasts at least a decade. Probably longer.
![[image]](https://i.imgur.com/l7YHpFgl.jpg)
![[image]](https://i.imgur.com/SebJAESl.jpg)
2018 Minnie Winnie 25b New to us 3/2021
Former Rental Owners Club #137
2003 Itasca Spirit 22e 2009-2021
|
schlep1967
Harrisburg, PA
Senior Member
Joined: 12/08/2005
View Profile
Good Sam RV Club Member
|
I didn't have any tape on hand. I did have a tube of Lap Sealant handy.
This post is more of a reminder to revisit the SEAL under the covers than a recommendation of what to seal it with.
|
Lwiddis
Cambria, California area
Senior Member
Joined: 08/12/2016
View Profile
Good Sam RV Club Member
 Offline
|
Good tip. Thank you.
Winnebago 2101DS TT & 2020 Chevy Silverado 1500 LTZ Z71, WindyNation 300 watt solar-Lossigy 200 AH Lithium battery. Prefer boondocking, USFS, COE, BLM, NPS, TVA, state camps. Bicyclist. 14 yr. Army -11B40 then 11A - (MOS 1542 & 1560) IOBC & IOAC grad
|
hornet28
Muskegon Mi.
Senior Member
Joined: 07/27/2017
View Profile
Good Sam RV Club Member
Offline
|
The Max Air cover isn't meant to be caulked/sealed.
Maxx Air vent cover installation by RV Education 101 - YouTube
|
|
|
Ron3rd
Upland, CA USA
Senior Member
Joined: 03/22/2004
View Profile
Good Sam RV Club Member
Offline
|
That's why I like the Maxx Air II that has the quick release pins so you can easily check the condition of the vent base caulk. The vent cover itself is never caulked as noted above.
2016 6.7 CTD 2500 BIG HORN MEGA CAB
2013 Forest River 3001W Windjammer
Equilizer Hitch
Honda EU2000
"I have this plan to live forever; so far my plan is working"
|
schlep1967
Harrisburg, PA
Senior Member
Joined: 12/08/2005
View Profile
Good Sam RV Club Member
|
My Maxx Air was installed by Open Range. They used Butyl tape and then self leveling caulk. And they broke the plastic at every one of the corners when the tightened down the screws. We don't plan on having this trailer much longer. At 12 years old it has bounced down the road enough times I don't want to go into retirement with it. Hopefully the new one will get the quick connect Maxx Air II's.
|
Dusty R
Charlotte Michigan 48813
Senior Member
Joined: 04/05/2003
View Profile
Offline
|
I put a MaxxAir 1200T on our MH. That was the one that had about an 145* arc, which would not allow rain in.
We traded that MH for a new one, and I went to get a new MaxxAir 1200T to put on the new MH and found that they were no longer made. Wish I could find a good used one.
|
hornet28
Muskegon Mi.
Senior Member
Joined: 07/27/2017
View Profile
Good Sam RV Club Member
Offline
|
schlep1967 wrote:My Maxx Air was installed by Open Range. They used Butyl tape and then self leveling caulk. And they broke the plastic at every one of the corners when the tightened down the screws. We don't plan on having this trailer much longer. At 12 years old it has bounced down the road enough times I don't want to go into retirement with it. Hopefully the new one will get the quick connect Maxx Air II's.
I sure wouldn't have them do any work on my unit if that's their level of competence
|
LarryJM
NoVa
Senior Member
Joined: 11/09/2007
View Profile
|
schlep1967 wrote:My Maxx Air was installed by Open Range. They used Butyl tape and then self leveling caulk. And they broke the plastic at every one of the corners when the tightened down the screws. We don't plan on having this trailer much longer. At 12 years old it has bounced down the road enough times I don't want to go into retirement with it. Hopefully the new one will get the quick connect Maxx Air II's.
If I'm understanding your post the folks at Open Range were idiots since the Max Air covers an NOT ATTACHED DIRECTLY to the roof. you attach brackets to the actual vertical part of the vent flange and then the Max Air cover is attached to that. The Max Air cover never actually touches the roof ... it sits about 1/4" off the roof so it's impossible for water to get trapped between the cover and the actual roof vent.
Larry
2001 standard box 7.3L E-350 PSD Van with 4.10 rear and 2007 Holiday Rambler Aluma-Lite 8306S Been RV'ing since 1974.
RAINKAP INSTALL////ETERNABOND INSTALL
|
|
|
