Good Sam Club Open Roads Forum: Tech Issues: Fuse Box locations
Open Roads Forum Already a member? Login here.   If not, Register Today!  |  Help

Newest  |  Active  |  Popular  |  RVing FAQ Forum Rules  |  Forum Posting Help and Support  |  Contact  

Search:   Advanced Search

Search only in Tech Issues

Open Roads Forum  >  Tech Issues

 > Fuse Box locations

Reply to Topic  |  Subscribe  |  Print Topic  |  Post New Topic  | 
Sargehut234

Cajun Country

Full Member

Joined: 08/11/2006

View Profile


Offline
Posted: 04/02/22 09:54am Link  |  Quote  |  Print  |  Notify Moderator

2008 Winnebago Destination 37G workhorse chassis.
Cab AC compressor clutch not engaged, so I thought I would start with fuses.
Chassis manuel gives general location and says refer to coach builder manuel.
Winne manuel offers nothing (that I could find) about fuse box locations.
I appreciate any help on this matter.
SARGE

Gdetrailer

PA

Senior Member

Joined: 01/05/2007

View Profile



Posted: 04/02/22 10:31am Link  |  Quote  |  Print  |  Notify Moderator

Can't help on finding the fuse box, most likely due to age the system may have leaked enough refrigerant to prevent the pressure switch from turning on the compressor which is more likely than a blown fuse.

The way A/C systems are setup on modern vehicles they have a pressure switch connected to monitor the refrigerant pressure. If not enough pressure the switch will not allow compressor clutch to engage and is a very common problem..

If you know someone who has a set of refrigerant gauges, have them check to pressure on the system.

If a bit low may just need a little top off, if very little to no pressure then may need to find the leak and repair.

Another possibility is the compressor clutch gap is too wide to engage due to wear.. You can pull the connection going to the compressor and check to see if you get voltage with A/C turned on.. If you get voltage then the clutch may be worn and not able to engage. Some clutches the gap may be adjustable by changing/removing the shims on the clutch. If gap can't be adjusted then a new clutch is in order.

Sargehut234

Cajun Country

Full Member

Joined: 08/11/2006

View Profile


Offline
Posted: 04/02/22 10:58am Link  |  Quote  |  Print  |  Notify Moderator

Thank you for that. I did take note on the first inspection that the compressor is newer than the rest of the belt driven components.
If I recall correctly you could jump the connection at the expansion valve to engage the clutch.
Thanks again!!

bikendan

Goodyear, Arizona

Senior Member

Joined: 11/21/2005

View Profile



Good Sam RV Club Member

Offline
Posted: 04/02/22 11:53am Link  |  Quote  |  Print  |  Notify Moderator

Have you tried a Winnebago owners forum?


Dan- Firefighter, Retired">, Shawn- Musician/Entrepreneur">, Zoe- Faithful Golden Retriever(RIP">), 2014 Ford F150 3.5 EcoboostMax Tow pkg, 2016 PrimeTime TracerAIR 255 w/4pt Equalizer and 5 Mtn. bikes and 2 Road bikes

enblethen

Moses Lake, WA

Senior Member

Joined: 01/05/2005

View Profile






Posted: 04/02/22 11:54am Link  |  Quote  |  Print  |  Notify Moderator

Have you checked in the battery control center? some are under the hood driver's side firewall.
If not there, with the aid of a helper operate the battery disconnect. They are commonly adjacent to the battery control center.


Bud
USAF Retired
Pace Arrow

2003 Chev Ice Road Tracker


Gdetrailer

PA

Senior Member

Joined: 01/05/2007

View Profile



Posted: 04/02/22 01:28pm Link  |  Quote  |  Print  |  Notify Moderator

Sargehut234 wrote:

Thank you for that. I did take note on the first inspection that the compressor is newer than the rest of the belt driven components.
If I recall correctly you could jump the connection at the expansion valve to engage the clutch.
Thanks again!!


Correct.

You can also use that switch connection to see if there is voltage present when the A/C is turned on. No voltage on either side then the issue could be a fuse or even the inside control panel.

Voltage on one side and none on the other side then refrigerant pressure most likely too low..

ItsyRV

Lost on the Blue Ridge Parkway

Senior Member

Joined: 10/02/2018

View Profile



Good Sam RV Club Member


Posted: 04/02/22 06:01pm Link  |  Quote  |  Print  |  Notify Moderator

Based on the generic owner's manual and the wiring diagrams for that year and model, it looks like the chassis electrical fuses and the coaches 12 volt electrical fuses/breakers are all located in a compartment by the front wheel. Can't tell if the access is inside or outside.


1994 Itasca SunDancer 21RB - Chevy G-30 chassis.


Trackrig

Spent the summer in Conconuly, Wa, MH now in Vanco

Senior Member

Joined: 05/15/2011

View Profile


Offline
Posted: 04/02/22 11:54pm Link  |  Quote  |  Print  |  Notify Moderator

A friend chased an electrical problem on his A/C for ages. He finally found they had installed an additional in-line fuse that wasn't in the fuse box.................

Bill


Nodwell RN110 out moose hunting. 4-53 Detroit, Clark 5 spd, 40" wide tracks, 10:00x20 tires, 16,000# capacity, 22,000# weight. You know the mud is getting deep when it's coming in the doors.


allbrandauto

maryland

Senior Member

Joined: 09/19/2013

View Profile



Good Sam RV Club Member

Offline
Posted: 04/04/22 06:19am Link  |  Quote  |  Print  |  Notify Moderator

before going thru electrical problem put gauges on to see if you have freon in system no freon means no power to the compressor

Reply to Topic  |  Subscribe  |  Print Topic  |  Post New Topic  | 

Open Roads Forum  >  Tech Issues

 > Fuse Box locations
Search:   Advanced Search

Search only in Tech Issues


New posts No new posts
Closed, new posts Closed, no new posts
Moved, new posts Moved, no new posts

Adjust text size:




© 2023 CWI, Inc. © 2023 Good Sam Enterprises, LLC. All Rights Reserved.