mando_man
Aloha, OR
New Member
Joined: 03/01/2008
View Profile
 Offline
|
OK, so I pulled out the orifice and it was a little clogged. I also replaced the main burner. It ignites and stays lit. But now it has a noise. I've attached a video. It's hard to see because of the sunlight, but you can hear it. Is it the air mixture? Or is it the placement of the flame spread thingy?
Video
|
2112
Texas
Senior Member
Joined: 07/16/2011
View Profile
|
That's how my suburban sounds
2011 Ford F-150 EcoBoost SuperCab Max Tow, 2084# Payload, 11,300# Tow,
Timbrens, PullRite SuperGlide 2700 15K
2013 KZ Durango 2857
|
dougrainer
Carrolton, Texas
Senior Member
Joined: 06/11/2007
View Profile
Offline
|
Adjust the air fuel mixture. It should just roar, not have small cut outs. Doug
|
StirCrazy
Kamloops, BC, Canada
Senior Member
Joined: 07/16/2003
View Profile
|
open that air slot untill you start to see yellow in the flame, then close it off untill there is just a tiny bit of yellow on the tips. right now your not getting enough air, it wont get any quieter but it will be adjusted properly. I have the same water heater and that sounds normal.
Steve
2014 F350 6.7 Platinum
2016 Cougar 330RBK
1991 Slumberqueen WS100
|
|
|
