Make and model: Atwood Hydroflame 8525-IVComplaint: Furnace clicks but fails to ignite, then goes into lockout mode after three attempts. Control board has green light, turns to red during ignition attempt and then back to green after failure, then n...
Hey guys!It's been a banner trip across the country this week. I'm currently at a repair shop in Cheyenne, WY, waiting on fuel pump replacement to commence tomorrow morning. I'm pretty sure I've got a failing fuel pump, but I'd love a second opinion....
Hi all! I've lurked here for AGES to fix all my tech issues; you're all very helpful. I'm looking for some info about my Onan Microlite 4KY Spec H generator.The gist of my question is this: When it's running correctly, should I NEVER hear a surge and...
I cleaned the burner orifice last time I was diagnosing: Took off the L-shaped connector between the valve and chamber, removed the pinhole orifice, soaked in alcohol, did some scrubbing with a few strands of stranded copper wire.
Alrighty, did some more work, no joy so far:Removed burner/valve/etc. assembly and observed spark electrode. In shaded daylight, couldn't see spark when I heard spark click. Separated electrode tips until they were about 3/16" apart. Thereafter obser...
enblethen wrote:While it is clicking check to see if there is voltage from circuit board to the gas valve.Another is to verify that the two coils on the gas valve have continuity.OK, so checking voltage across the closest coil's positive and ground w...
