May-14-2020 11:16 AM
May-21-2020 08:41 AM
May-20-2020 07:15 AM
May-20-2020 06:21 AM
May-15-2020 11:10 AM
Executive wrote:dougrainer wrote:
.../snip/ because I made sure the side Camera's had there own 12 volt supply. Doug
Maybe that's the key here; Obviously it's a wiring issue. So that, then, begs the question. Was the system wired correctly? Can you wire the system without providing power individually to each camera? Perhaps the OP skipped or modified a step. :h ....Dennis
May-15-2020 08:46 AM
dougrainer wrote:
.../snip/ because I made sure the side Camera's had there own 12 volt supply. Doug
May-15-2020 08:01 AM
rgatijnet1 wrote:dougrainer wrote:
Per the Instructions, IF YOU DO NOT USE THE TRIGGER HARNESS(connecting the trigger wires) THE TURN SIGNALS SHOULD NOT AFFECT THE OPERATION. If the Camera's have there own 12 volt supply and not connected to the original Furrion harness, the system should operate as the OP desires. You do NOT have to use the Trigger harness for install. Doug
Well then they should be working, right???? :B
May-15-2020 04:24 AM
dougrainer wrote:
Per the Instructions, IF YOU DO NOT USE THE TRIGGER HARNESS(connecting the trigger wires) THE TURN SIGNALS SHOULD NOT AFFECT THE OPERATION. If the Camera's have there own 12 volt supply and not connected to the original Furrion harness, the system should operate as the OP desires. You do NOT have to use the Trigger harness for install. Doug
May-14-2020 03:11 PM
May-14-2020 01:06 PM
May-14-2020 11:57 AM
May-14-2020 11:34 AM