May-27-2019 05:44 PM
Jul-15-2019 05:16 AM
Jul-14-2019 07:45 PM
Jul-13-2019 10:46 AM
Jul-13-2019 10:11 AM
May-28-2019 06:35 PM
BillM2 wrote:
Should I remove the entire side rails or just enough to work the roof? I know the rear has to come off. Would a heat gun on a low setting help release the membrane from the sub material?
The membrane is white so I’m assuming it’s EPDM?
And if the insulation is gone, what do you recommend to replace. Rigid or bat?
May-28-2019 07:34 AM
May-28-2019 07:22 AM
May-28-2019 06:09 AM
May-28-2019 04:34 AM
May-28-2019 03:58 AM
JIMNLIN wrote:
Don't cut the membrane and make another seam up there. Its just another source of leaks.
Do it right.
Remove all the screws in the cap/roof membrane molding.....remove screws on the drip rails both sides....other roof fixtures and roof jacks past the rotted area.....then roll the membrane past the area your going to replace.
Replace damaged wood......then replace it all with a good seal job.
Let google and youtube work for you on this project.
May-27-2019 07:59 PM
May-27-2019 07:04 PM