โSep-23-2018 10:08 PM
โSep-26-2018 07:50 AM
โSep-26-2018 06:15 AM
โSep-26-2018 05:13 AM
โSep-25-2018 07:55 PM
โSep-25-2018 07:48 PM
โSep-25-2018 11:34 AM
groundhogy wrote:
So would a normal welder have thin tungsten rods on hand?
Just measured the diameter at 0.084 inches. Seems an odd diameter.
โSep-24-2018 07:29 PM
โSep-24-2018 07:28 PM
โSep-24-2018 07:24 PM
โSep-24-2018 06:20 PM
โSep-24-2018 05:25 PM
โSep-24-2018 03:01 PM
wa8yxm wrote:
Ok the ignightor is TWO of those points (wires. pipes Rods) One is ground, one is IGNITION and one is Thermocouple (this also has a ground part)
The Thermocouple is made of TWO metals. when heated it makes 0.480 volts at low current.. that's the wire that goes to the control board.
See above suggeions for TIG wire for the spark rod
โSep-24-2018 02:53 PM
โSep-24-2018 01:41 PM